SPIway

SPIway

SPIway - Teensy++ 2.0 SPI flasher for PS4

Source: NORway on github

Pinout

Macronix MX25L1006E Pinout

Winbond 25X10CLYA1 Pinout

Winbond 25Q80BV Pinout

Macronix MX25L25635FMI-10G Pinout

Teensy 2.0++ SPIway Pinout

8-Pin	16-pin	Usage	Teensy++ 2.0 SPIway	Description
-	1	SIO3	B5	8pin: Not Available - not used / 16pin: Serial Data Input & Output (for 4xI/O read mode)
8	2	VCC	+5V pad	+3V DC Power Supply
7	3	HOLD#/RESET#	B6	8pin: Hold, to pause the device without deselecting the device / 16pin: Hardware Reset Pin Active low
-	4	NC	NC	No Connection
-	5	NC	NC	No Connection
-	6	NC	NC	No Connection
1	7	CS#	B0	Chip Select
2	8	SO/SIO1	B3	Serial Data Output (for 1 x I/O) or Serial Data Input & Output (for 2x I/O or 4x I/O read mode)
3	9	WP#/SIO2	B4	Write Protection: connect to GND or Serial Data Input & Output (for 4x I/O read mode)
4	10	GND	GND	Ground
-	11	NC	NC	No Connection
-	12	NC	NC	No Connection
-	13	NC	NC	No Connection
-	14	NC	NC	No Connection
5	15	SI/SIO0	B2	Serial Data Input (for 1 x I/O) or Serial Data Input & Output (for 2x I/O or 4x I/O read mode)
6	16	SCLK	B1	Clock Input

Use short wires, esp. if you are not adding the 0.1µF capacitor between ground and vcc as close as possible to the chip

Changelog

• v0.10
  • Initial release
  • Support for Macronix MX25L25635FMI-10G and MX25L25635FZ2I-10G
• v0.20
  • Added README
  • Added support for Macronix MX25L1006E
  • Added support for Winbond W25X10CL
• v0.30
  • Added support for Winbond W25Q80BV (thx to "Socketz"!)

Usage Examples

The easiest ways!

Required equipment