Template:Updating Bitstreams 1.2/1.21

From PS3 Developer wiki
Jump to navigation Jump to search
  1. Install the Infectus driver for Injectus --> connect only the Injectus via usb to PC
  2. Disconnect the Injectus and connect it via 15 pin cable to the Progskeet 1.2, then connect it to the PC.
    Load the Bitstream with the Infectus Programmer.
  3. When it´s done disconnect it from the PC and connect the Slaveboard instead of the Injectus. Then connect it to the PC.
    Install the driver manually.

If it´s done, it will look like this:


Error Codes

Error 3 Cannot reset hardware, power/communications issue
Error 5 Hardware timeout
Error 6 Wrong model number, see also Error 3
Error 8 Malfunctioning port
Error 9 Programmer execution error (failed consistency check), see Error 3 and Error 5
Error 10 Error in programming algorith, please contact techsupport
Error 11 There is no data in the buffer, You must load a file or read a chip
Error 14 There is no chip in the programmer
Error 15 The chip is not inserted in the programmer, check pins
Error 16 The chip is inserted backwards
Error 17 Out of base memory
Error 18 Temporary file error
Error 21 Cannot program
Error 22 Cannot erase
Error 23 Invalid electronic signature in chip (device ID)
Error 24 Invalid electronic signature in chip (algorithm ID)
Error 26 Device is not blank
Error 27 Device is not secured
Error 31 Database file is invalid, The EXE file is corrupt
Error 32 Sorry, algorithm not found. Please call techsupport
Error 33 You must reselect the chip you want to program
Error 36 You must properly install the correct socket module
Error 39 Device already secured
Error 44 Internal error. Please call techsupport
Error 46 AFS software required to execute this function
Error 47 Self-test failed. This unit may need service
Error 57 You must purchase support for this device
Error 70 The buffer data cannot be used to program