Template:Updating Bitstreams 1.2/1.21

Install the Infectus driver for Injectus --> connect only the Injectus via usb to PC
Disconnect the Injectus and connect it via 15 pin cable to the Progskeet 1.2, then connect it to the PC.
Load the Bitstream with the Infectus Programmer.
When it´s done disconnect it from the PC and connect the Slaveboard instead of the Injectus. Then connect it to the PC.
Install the driver manually.

If it´s done, it will look like this:

Error Codes:

Error 3	Cannot reset hardware, power/communications issue
Error 5	Hardware timeut
Error 6	Wrong model number, see also Error 3
Error 8	Malfunctioning port
Error 9	Programmer execution error (failed consistency check), see Error 3 and Error 5
Error 10	Error in programming algorith, please contact techsupport
Error 11	There is no data in the buffer, You must load a file or read a chip
Error 14	There is no chip in the programmer
Error 15	The chip is not inserted in the programmer, check pins
Error 16	The chip is inserted backwards
Error 17	Out of base memory
Error 18	Temporary file error
Error 21	Cannot program
Error 22	Cannot erase
Error 23	Invalid electronic signature in chip (device ID)
Error 24	Invalid electronic signature in chip (algorithm ID)
Error 26	Device is not blank
Error 27	Device is not secured
Error 31	Database file is invalid, The EXE file is corrupt
Error 32	Sorry, algorithm not found. Please call techsupport
Error 33	You must reselect the chip you want to program
Error 36	You must properly install the correct socket module
Error 39	Device already secured
Error 44	Internal error. Please call techsupport
Error 46	AFS software required to execute this function
Error 47	Self-test failed. This unit may need service
Error 57	You must purchase support for this device
Error 70	The buffer data cannot be used to program

Navigation menu