Internal
Jump to navigation
Jump to search
Internal Pads
At this moment it is not yet documented what use the pads have (e.g. Service Connectors, SPI, I2C, JTAG, PCIe etc.)
pads 1 (GbLAN)
GbLAN MDIO
Pin | Name | Description |
---|---|---|
1 | Vcc | Internal +5V |
2 | Vcc | Internal +5V |
3 | Vcc | Internal +5V |
4 | Vcc | Internal +5V |
5 | ||
6 | ||
7 | Gnd | Internal ground |
8 | ||
9 | Gnd | Internal ground |
10 | ||
11 | Gnd | Internal ground |
12 | ||
13 | Gnd | Internal ground |
14 | Gnd | Internal ground |
pads 2 (MediaCon)
MediaCon debug (No activity was detected so far. It looks to be disabled / turned off)
Pin | Name | Description |
---|---|---|
1 | ||
2 | Gnd | Internal ground |
3 | ||
4 | ||
5 | ||
6 | ||
7 | ||
8 | Gnd | Internal ground |
9 | ||
10 | Gnd | Internal ground |
11 | 3.3V when console is started | |
12 | ||
13 | ||
14 | ||
15 | ||
16 | ||
17 | Gnd | Internal ground |
18 | ||
19 | Gnd | Internal ground |
20 | Vcc | +3.3V_STBY power (always on, including the deep standby) |
pads 3 (A01-C0L)
Pin | Name | Description |
---|---|---|
1 | ||
2 | ||
3 | ||
4 | ||
5 | ||
6 | Gnd | Internal ground |
7 | I2C | I2C bus (100 kHz clock) |
8 | Gnd | Internal ground |
9 | ||
10 | ||
11 | ||
12 | ||
13 | Gnd | Internal ground |
14 | ||
15 | ||
16 | ||
17 | Gnd | Internal ground |
18 | ||
19 | ||
20 | ||
21 | ||
22 | Gnd | Internal ground |
23 | ||
24 | ||
25 | Gnd | Internal ground |
26 | ||
27 | ||
28 | ||
29 | ||
30 |
UART
Same layout is used for SAA-K23, SAB-K02 / SAA-001, SAB-001 (pads are present on SAC-001 too, but layout slightly differs)
3.3V CMOS TTL - 115200, n, 8.1
JaiBrute v2 MD5:f71e4beebbbb859f74dc536c9e824acb
JaiBrute v1 MD5:f7a7e0f970d5e86ef110d2d4ff0ed1b1
UART0 Console
Pin | Name | Description |
---|---|---|
GND | Ground | |
U0C_TX | UART0 Console Transmit | |
U0C_RX | UART0 Console Receive |
Note: quite useless, as the output is zeroed out by "spaces" on retail models
UART MediaCon
Pin | Name | Description |
---|---|---|
GND | Ground | |
UMC_TX | UART MediaCon Transmit | |
UMC_RX | UART MediaCon Receive |
Note: quite simular to PS3 Syscon UART
|