Teensy++ 2.0
Teensy 2.0 ++ Information
- NORway (not working link, need working mirror)
Hardware Picture
Hardware Installations (Case Modifications by CECH Model)
First open the PS3. Follow youtube videos to learn how (Just search).
Once opened, look at the motherboard model printed there. Depending on which model you have follow the case modifications below to install teensy.
There are two methods to use a Teensy 2.0++ Flasher.
1.) Install while the PS3 is somewhat opened still with everything plugged in. (Be careful of shorts.)
2.) Internal Case Modifications. This is the best way to go as you can install the teensy inside of the PS3 for later use. This is the advantage of using a Teensy 2.0++ because it's just small enough to install inside the PS3 with a little case modification. Other flashers are generally too large to do this with the PS3 closed up. You will find there is just no room for it.
DYN-001
This model requires the following:
1x Dremel Tool 1x Drill 1x Roll of Double Sided Foam Tape 1x 30AWG Kynar Wire or 26 AWG Kynar Wire. (Few have reported 30AWG may be too small and has interference but does work if done well.) 1x Torque 8 Screwdriver 1x Regular Phillips Head Screwdriver 1x Solder (Can be leaded or no-lead) 1x Soldering Iron (Radioshack 15-30 Watt Will Work.) 1x Pair Of Steady Hands (Not Joking. Tremor Fingers will not cut it. You are soldering 40+ points and all must be done very well.) 1x Good Lighting (Either very well lighted room, or a Lamp. You need to be able to check your work.) 1x Magnifying Glass (To check your soldering joints.) 1x Patience.
JSD-001
..