Editing PS5 Modifications

== Dumping the Serial Flash ==
The serial flash being used in the PS5 (at the time of writing) is a Winbond W25Q16JVNIM. It's about 2MB and is 150mil in size.
Here's a pinout diagram of the flash.

        +---------------+
        |o              |
 /CS+---+    WINBOND    +---+VCC
        |  W25Q16JVNIM  |
 /MISO+-+               +---+/HOLD /RESET
        |               |
 /WP+---+               +---+SCLK
        |               |
 GND+---+               +---+/MOSI
        +---------------+

In this guide, we will be using a Raspberry Pi to dump the flash (teensy boards may work too)
Connect the pins to the GPIO header according to this table:
{| class="wikitable"
|+Connections
|-
|Flash
|RPI
|-
|/CS
|GPIO 8
|-
|/MISO
|GPIO 9
|-
|/WP
|GND
|-
|GND
|GND
|-
|VCC
|3v3
|-
|/HOLD
|3v3 via 10k
|-
|SCLK
|GPIO 11
|-
|MOSI
|GPIO 10
|- 
|}
<small>Use this site to find the pinout for your Raspberry Pi: https://pinout.xyz/pinout/spi#</small>

I will release my own tools later on, but I think flashrom works for now (haven't tested yet)

<small>See this page for more info about the flash: https://www.digikey.com/htmldatasheets/production/3221237/0/0/1/W25Q16JV.pdf</small>