PS5 Modifications: Difference between revisions
Jump to navigation
Jump to search
(Created page with "== Dumping the Serial Flash == The serial flash being used in the PS5 (at the time of writing) is a Winbond W25Q16JVNIM. It's about 2MB and is 150mil in size. Here's a pinout...") Β |
|||
Line 50: | Line 50: | ||
I will release my own tools later on, but I think flashrom works for now (haven't tested yet) | I will release my own tools later on, but I think flashrom works for now (haven't tested yet) | ||
<small>See this page for more info about the flash: https://www.digikey.com/htmldatasheets/production/3221237/0/0/1/W25Q16JV.pdf</small> |
Revision as of 16:12, 24 December 2020
Dumping the Serial Flash
The serial flash being used in the PS5 (at the time of writing) is a Winbond W25Q16JVNIM. It's about 2MB and is 150mil in size. Here's a pinout diagram of the flash.
+---------------+ |o | /CS+---+ WINBOND +---+VCC | W25Q16JVNIM | /MISO+-+ +---+/HOLD /RESET | | /WP+---+ +---+SCLK | | GND+---+ +---+/MOSI +---------------+
In this guide, we will be using a Raspberry Pi to dump the flash (teensy boards may work too) Connect the pins to the GPIO header according to this table:
Flash | RPI |
/CS | GPIO 8 |
/MISO | GPIO 9 |
/WP | GND |
GND | GND |
VCC | 3v3 |
/HOLD | none |
SCLK | GPIO 11 |
MOSI | GPIO 10 |
Use this site to find the pinout for your Raspberry Pi: https://pinout.xyz/pinout/spi#
I will release my own tools later on, but I think flashrom works for now (haven't tested yet)
See this page for more info about the flash: https://www.digikey.com/htmldatasheets/production/3221237/0/0/1/W25Q16JV.pdf