DualSense HID Commands

From PS5 Developer wiki
Jump to navigation Jump to search

Get MCU Unique ID[edit | edit source]

Get MediaTek Main MCU Unique ID

	ReportID = 128,
	DeviceID = 1,
	ActionID = 9

Read Device Info[edit | edit source]

	ReportID = 128,
	DeviceID = 1,
	ActionID = 12

Erase Device Info [DANGER][edit | edit source]

	ReportID = 128,
	DeviceID = 1,
	ActionID = 13

Spider DSP Init Get Status[edit | edit source]

	ReportID = 129,
	DeviceID = 16,
	ActionID = 1

Spider DSP Get Status[edit | edit source]

	ReportID = 129,
	DeviceID = 16,
	ActionID = 2

Spider DSP Patch Finalize[edit | edit source]

	ReportID = 128,
	DeviceID = 16,
	ActionID = 5

Spider DSP Finalize Get Status[edit | edit source]

	ReportID = 129,
	DeviceID = 16,
	ActionID = 5

Spider DSP Firmware Patch[edit | edit source]

	ReportID = 128,
	DeviceID = 16,
	ActionID = 2,
	DataLen = 57

Spider DSP Firmware Patch Init[edit | edit source]

	ReportID = 128,
	DeviceID = 16,
	ActionID = 1

Spider DSP Firmware Verify[edit | edit source]

	ReportID = 128,
	DeviceID = 16,
	ActionID = 3

Spider DSP Firmware Verify Status[edit | edit source]

	ReportID = 129,
	DeviceID = 16,
	ActionID = 5

Spider DSP Firmware Verify Request[edit | edit source]

	ReportID = 128,
	DeviceID = 16,
	ActionID = 7

Spider DSP Firmware Verify Request Status[edit | edit source]

	ReportID = 129,
	DeviceID = 16,
	ActionID = 7

Get TP UID[edit | edit source]

Get Touch Panel Ubique ID

	ReportID = 128,
	DeviceID = 5,
	ActionID = 2

Get TP Version[edit | edit source]

Get Touch Panel Version

	ReportID = 128,
	DeviceID = 5,
	ActionID = 4

Get Table ID[edit | edit source]

	ReportID = 164,
	DeviceID = 3,
	ActionID = 2,
	DataLenLocal = 5

Reset[edit | edit source]

	ReportID = 128,
	DeviceID = 1,
	ActionID = 1

Request Table ID[edit | edit source]

	ReportID = 160,
	DeviceID = 3,
	ActionID = 2

Reboot Secure Boot Loader[edit | edit source]

	ReportID = 128,
	RebootCmd = 1

Read Patch Info[edit | edit source]

	ReportID = 128,
	DeviceID = 9,
	ActionID = 13

Get Firmware Info[edit | edit source]

    ReportID = 32

Start Gyroscope Offset[edit | edit source]

	ReportID = 144,
	ActionID = 1,
	DeviceID = 2,
	TargetID = 7

Get Gyroscope Offset State[edit | edit source]

	ReportID = 145,
	DeviceID = 2,
	TargetID = 7

Get BlueTooth Patch Data[edit | edit source]

	ReportID = 129,
	DeviceID = 14,
	ActionID = 3

Get BlueTooth Patch Info[edit | edit source]

	ReportID = 129,
	DeviceID = 9,
	ActionID = 13

Get Audio Codec State[edit | edit source]

	ReportID = 164,
	DeviceID = 16,
	ActionID = 1

Flash[edit | edit source]

	ReportID = 240,
	DownloadCmd = 0,
	DataLen = 57,
	WriteCmd = 1

Audio Codec Select[edit | edit source]

	ReportID = 160,
	DeviceID = 16,
	ActionID = 1

Blue Tooth Patch[edit | edit source]

	ReportID = 128,
	DeviceID = 14,
	ActionID = 2,
	DataLen = 57

Read Blue Tooth Patch[edit | edit source]

	ReportID = 128,
	DeviceID = 14,
	ActionID = 4

Read Blue Tooth Patch Info[edit | edit source]

	ReportID = 129,
	DeviceID = 14,
	ActionID = 4

Blue Tooth Patch Finalize[edit | edit source]

	ReportID = 128,
	DeviceID = 14,
	ActionID = 5

Blue Tooth Patch Init[edit | edit source]

	ReportID = 128,
	DeviceID = 14,
	ActionID = 1

Blue Tooth Patch Restart[edit | edit source]

	ReportID = 128,
	DeviceID = 14,
	ActionID = 6

Blue Tooth Patch Verify[edit | edit source]

	ReportID = 128,
	DeviceID = 14,
	ActionID = 3

Blue Tooth Restart Result[edit | edit source]

	ReportID = 129,
	DeviceID = 14,
	ActionID = 6

Get BT Address[edit | edit source]

	ReportID = 129,
	DeviceID = 9,
	ActionID = 2,
	DataLen = 6

Set BT Address[edit | edit source]

    ReportID = 128,
	DeviceID = 9,
	ActionID = 1,
	ReadCmd = 2,
	DataLen = 6

Set BlueTooth Disable Enable[edit | edit source]

	ReportID = 128,
	DeviceID = 9,
	ActionID = 5,
	Param = 0

Set BlueTooth Enable[edit | edit source]

    ReportID = 128,
	DeviceID = 9,
	ActionID = 5,
	Param = 1

Set BlueTooth Table[edit | edit source]

    ReportID = 165,
	PowerTable = 1,
	RadioTable = 2,
	DataLen = 16,
	DataBegin = 0,
	PowerTableSize = 224,
	RadioTableSize = 112,
	DataMaxLen = (max value of a byte, 255)
	DataMinLen = 0

Set DFU Mode[edit | edit source]

Note 1: This command does not work with retail controllers 'tested with many controllers' but it may work with DVT/Prototype controllers. Note 2: The mainboard immediately boot into PBL (Primary Boot Loader) mode on the factory before flashing Main "Banana" firmware, then it will be disabled after that.

    ReportID = 160,
	DisableMode = 0,
	EnablePBLMode = 1,
	EnableSBLMode = 2,
	EnableMode = 1

Set Hardware Version[edit | edit source]

    ReportID = 128,
	DeviceID = 1,
	ActionID = 5

Write PCBAID[edit | edit source]

ReportID = 128,
	DeviceID = 1,
	ActionID = 3,
	DataLen = 6

Read PCBAID[edit | edit source]

ReportID = 128,
	DeviceID = 1,
	ActionID = 4,

Set Power Charge Off[edit | edit source]

	ReportID = 128,
	DeviceID = 2,
	ActionID = 3,
	Param0 = 208,
	Param1 = 38,
	Param2 = 117,
	Param3 = 192

Set Power Charge On[edit | edit source]

	ReportID = 128,
	DeviceID = 2,
	ActionID = 2,
	Param0 = 208,
	Param1 = 38,
	Param2 = 117,
	Param3 = 192

Get Read OTP[edit | edit source]

	ReportID = 164,
	DeviceID = 3,
	ActionID = 9

Set Read OTP[edit | edit source]

ReportID = 160,
	DeviceID = 3,
	ActionID = 9,
	Offset = 23,
	Length = 1

Set Secure Boot Loader[edit | edit source]

ReportID = 160,
	SetCmd = 2

Set VDD External Power Off[edit | edit source]

ReportID = 160,
	DeviceID = 17,
	ActionID = 1,
	Param = 0

Set VDD External Power On[edit | edit source]

ReportID = 160,
	DeviceID = 17,
	ActionID = 1,
	Param = 1

Venom Get Status[edit | edit source]

	ReportID = 129,
	DeviceID = 15,
	ActionID = 2

Set Venom FW Version[edit | edit source]

ReportID = 128,
	DeviceID = 6,
	ActionID = 3

Venom Finalize Get Status[edit | edit source]

	ReportID = 129,
	DeviceID = 15,
	ActionID = 5

Venom Firmware Patch[edit | edit source]

	ReportID = 128,
	DeviceID = 15,
	ActionID = 2,
	DataLen = 57

Venom Firmware Patch Init[edit | edit source]

	ReportID = 128,
	DeviceID = 15,
	ActionID = 1

Venom Firmware Verify[edit | edit source]

	ReportID = 128,
	DeviceID = 15,
	ActionID = 3

Venom Firmware Verify Request[edit | edit source]

	ReportID = 128,
	DeviceID = 15,
	ActionID = 7

Venom Firmware Verify Request Status[edit | edit source]

	ReportID = 129,
	DeviceID = 15,
	ActionID = 7

Venom Firmware Verify Status[edit | edit source]

	ReportID = 129,
	DeviceID = 15,
	ActionID = 5

Venom Init Get Status[edit | edit source]

	ReportID = 129,
	DeviceID = 15,
	ActionID = 1

Venom Patch Finalize[edit | edit source]

	ReportID = 128,
	DeviceID = 15,
	ActionID = 5

Set bonding[edit | edit source]

	ReportID = 128,
	DeviceID = 1,
	ActionID = 14

NVS Lock[edit | edit source]

  ReportID = 128, 
  DeviceID = 3,
  ActionID = 1,

NVS Unlock[edit | edit source]

  ReportID = 128, 
  DeviceID = 3,
  ActionID = 2,
  Param0 = 101,
  Param1 = 50,
  Param2 = 64,
  Param3 = 12

NVS Lock Status[edit | edit source]

  ReportID = 128, 
  DeviceID = 3,
  ActionID = 3,

Results:

0 - Unlocked 1 - Locked