Button Combos: Difference between revisions

From PSP Developer wiki
Jump to navigation Jump to search
m (→‎More System Information: Pressing Left Dpad and Start, instead of just pressing Start, causes it to remain on the screen (this can be reliably reproduced))
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
= Enter Factory Service Mode =
== PSP-E1000 Factory Service Mode ==
* Your PSP must be fully powered off (not in sleep mode)
* Plug in your [[PSP Street Jigkick]] mini-B USB and have the Baryon Sweeper software running
* Hold down LTrigger + RTrigger + LeftDpad + Circle and turn on the PSP, keep buttons held until the PSP boots into service mode
* The code responsible for this combo is located in street syscon firmware


* for psp E1000
== Reset System Settings ==
* Hold down LTrigger + RTrigger + LeftDpad + Circle when USB is plugged in (baryonsweeper is started) and DC is connected
* Turn on Power on console without letting go of buttons


= More System Information =
* Your PSP must be fully powered off (not in sleep mode)
* Hold Triangle + Square + Select + Start and turn on the PSP, keep buttons held until the boot animation appears
* The code to toggle this is found in vshmain.prx


* for all psps
== More System Information ==
* Hold down LTrigger+RTrigger+Left Dpad+Square for a couple seconds (3) then let go and press start to show
* Navigate to Settings > System Settings > System Information
* to have it remain on display, press Left Dpad+start instead of just start
* Hold down LTrigger + RTrigger + Left Dpad + Square for a couple seconds (3) then let go and hold Start to display extra system information
* To have it remain on screen until you exit System Information, press Left Dpad while holding Start, then release both

Latest revision as of 13:32, 1 December 2023

PSP-E1000 Factory Service Mode[edit | edit source]

  • Your PSP must be fully powered off (not in sleep mode)
  • Plug in your PSP Street Jigkick mini-B USB and have the Baryon Sweeper software running
  • Hold down LTrigger + RTrigger + LeftDpad + Circle and turn on the PSP, keep buttons held until the PSP boots into service mode
  • The code responsible for this combo is located in street syscon firmware

Reset System Settings[edit | edit source]

  • Your PSP must be fully powered off (not in sleep mode)
  • Hold Triangle + Square + Select + Start and turn on the PSP, keep buttons held until the boot animation appears
  • The code to toggle this is found in vshmain.prx

More System Information[edit | edit source]

  • Navigate to Settings > System Settings > System Information
  • Hold down LTrigger + RTrigger + Left Dpad + Square for a couple seconds (3) then let go and hold Start to display extra system information
  • To have it remain on screen until you exit System Information, press Left Dpad while holding Start, then release both