alt. part no: 88SA8040C0-TBC1C000-P107 (SATA 1.5 Gb/s to PATA 133)
6-710-129-01 / IC3401
The 88SA8040 is an IC which consists of 9 bus transceivers (three state output) in a 24 pin package. Signals are transmitter from A to B when the direction control input (DiR) is at a high level, and from B to A when DiR is at a low level. When the enable input (G) is high, A and B are isolated. And this product has two terminals (V CCA, VCCB), VCCA is connected with control input and A bus side, VCCB is connected with B bus side. VCCA and V CCB are isolated. Consequently, it is best to change the level in case of two supply voltage coexist on one board and application of power management. Dropout Voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal value measured at 1V differential. For outputs below 2.5V, dropout voltage is the input-to-output voltage differential with the minimum input voltage 2.5V. Minimum input operating voltage is 2.5V.
No datasheet found/available : http://www.marvell.com/storage/system-solutions/sata-to-pata-bridge.jsp
Marvell 88SA8040C0-TBC1C000-P107 (SATA to PATA bridge)
No padouts have been listed (yet), please help to fill this in :)
| This article is marked for rewrite/restructuring in proper wiki format.
You can help PS3 Developer wiki by editing it.