CSW-001
Jump to navigation
Jump to search
This article is marked for rewrite/restructuring in proper wiki format. You can help PS3 Developer wiki by editing it. |
zapnutie, vypnutie, reset, eject panel, ktorý sa pripája k zakladnej doske 10 pin vodičom
panel pre modely PS3 FAT CECHA,B,C,E
On, off, reset, eject panel that connects to the motherboard 10 pin drivers
Panel for PS3 models FAT CECHA, B, C, E
http://www.playstation-servis.eu/power-eject-panel-d20.htm
Pin | Name | Connected to | Description | |
---|---|---|---|---|
On Motherboard | On Switch board | |||
1 | GND | GND | GND | Ground |
2 | SW_PWM | Syscon pad N9 | Testpad ? | FREQ. Intended to send a PWM signal to the switch board ? |
3 | RMC_IN | Syscon pad R10 Service Connector (CN4009) pin 17 |
Testpad ?. NC | ReMote Control INput The IR receiver component is missing in the Switch board but existed in some PS3 prototypes that was using SIRC protocol and SERV_SIRCS |
4 | POW_SW | Syscon pad B12 | Power Switch | |
5 | EJECT_SW | Syscon pad A12 | Eject Switch | |
6 | POW_LED | Syscon pad M7 | Green led | |
7 | STBY_LED | Syscon pad N7 | Red led | |
8 | BD_LED | BluRay connector (CN3221) pin 50 | Blue led | |
9 | GND | GND | GND | Ground |
10 | +5V_EVER | Power Supply connector (CN6005) pins 4 and 5 | VCC | 5V Standby |
|